My FlashPro logs are showing a voltage drop under WOT as low as 12.1! What's the problem? Bad alternator, loose belt, bad battery, to much draw from amp for 8" sub, bad ground? What should I do?
i want to install a rosen aftemarket hu in my 2012 civic exl. it comes with steering wheel learning harness, i need to know the voltage of the blue and pink wires on the factory radio harness. any help would be appicated. do you see any problems with this install.:wigglesmiley:
Hi guys, i think i might have a problem with my battery. Can you guys check the battery voltage when the engine is on but not started? i read 11.0 Volts. Just want to be sure thats normal.
Thanks
Anyone know how it is done? I was thinking if it is simply a resistor or regulator I MOSFET could be used to have hids turn on when either the drl are on or the high beam. Then put a load resistor to make sure there is no error messages. I think it would work as long as they aren't using PWM...
Didn't start in the cold!?
Hey guys,
I currently lease a brand new 2012 Si Coupe (Since end of September, 2011) and under 10K kms, so my surprise came this morning (after the car has been sitting out all night in about -2 degrees celsius/28.4 degrees farenheit), it wouldn't start! :SHOCKED...