Just arrived in the mail today so after making a few runs had a little down time here at work so i decided to install it. IT coms with the spacer, gasket, all extended bolts. There is also a black plasic piece that screws into a hole on side of spacer. this is hole you can use later if you add nitrous so thats why its there.
Next i a pic of throttle body and intake tube which will need to be removed.
close up of throttle body
Loosen clamp with socket.
Loosen this clamp next
Next take pliers and pinch this and pull out tube on top of hose.
Now pull intake hose off and lay aside.
Next remove all 4 bolts on throttle body pictured here.. you will also notice a smaller bolt on side of throttle body which clamps a line to throttle body. Remove that bolt and lay aside. you will need that smaller bolt to reattach latr so dont lose.
Remove throttle body. Now you will see a orange gasket on inside of where throttle body attaches..leave that there. Gasket you have in box will go between throttle body and spacer..it does not go between spacer and engine side. notch on spacer is suppose to be facing up. Dont forget to put that black plastic screw in side of throttle body... just in case you forgot about it. Now bolt throttle body andspacer back on motor with longer bolts included with spacer. Reattach everything you took off in reverse order and your done. took me 15-twenty minutes...not hard job for even inexperienced modders.
Heres a picture of spacer on.
Engine pic after install
Will post a review of product when i get off work tommorrow.
Next i a pic of throttle body and intake tube which will need to be removed.
close up of throttle body
Loosen clamp with socket.
Loosen this clamp next
Next take pliers and pinch this and pull out tube on top of hose.
Now pull intake hose off and lay aside.
Next remove all 4 bolts on throttle body pictured here.. you will also notice a smaller bolt on side of throttle body which clamps a line to throttle body. Remove that bolt and lay aside. you will need that smaller bolt to reattach latr so dont lose.
Remove throttle body. Now you will see a orange gasket on inside of where throttle body attaches..leave that there. Gasket you have in box will go between throttle body and spacer..it does not go between spacer and engine side. notch on spacer is suppose to be facing up. Dont forget to put that black plastic screw in side of throttle body... just in case you forgot about it. Now bolt throttle body andspacer back on motor with longer bolts included with spacer. Reattach everything you took off in reverse order and your done. took me 15-twenty minutes...not hard job for even inexperienced modders.
Heres a picture of spacer on.
Engine pic after install
Will post a review of product when i get off work tommorrow.