9th Gen Civic Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter · #1 ·
Question, I just bought a set of used skunk 2 struts and lowering springs, what I didn’t notice until now is the rear lower bushing on one is shot to the point I can take out the rod where the bolt goes through, has anyone had this issue and is there a way to replace it or maybe fix it with some 3m window weld. I haven’t put it in the car just yet. I can get some images tomorrow if it on the strut…. Any input is helpful..
 

Attachments

1 - 2 of 2 Posts
Top