9th Gen Civic Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
1,347 Posts
Discussion Starter · #1 · (Edited)
What are your thoughts on this mod?
1. Not worth it.
2. Hard to change out?
3. Not worth the money and time to replace?
4. May void warranty or certainly interfere with it.

There are two right now.
- CT Engineering Heat Resistant Intake Manifold Gasket (various models) $49.00 (est. install time 3hrs!). No dyno from them either.
- P2R 06+ Civic Si Thermal Intake Manifold Gasket (don't know if this fits our cars) $34.99. No dyno from them also.

Here's a post from Hondata. They make them too, but not for our Si's
 

·
Registered
Joined
·
935 Posts
You're probably gonna have next to no results on our K24Z7 as only a small portion of the manifold (about 2 inches...) is made of aluminum, but it would rock on a RBC\RRC manifold that is entirely made of aluminum! :)

Marko!
 

·
2013 Jan K24 ROTM Winner
Joined
·
2,099 Posts
I like the gaskets but I would never do it unless I was changing the manifold which is why I have the hondata k20z3 intake manifold gasket
 
1 - 3 of 3 Posts
Top