Hi Everyone,
I just recently swapped my driver side seat and wanted to give everyone some info/tips on this as I found it hard to find everything in one place. Below I will place all I have, i'm not perfect so please ask questions or post corrections. Please note that this is what worked for me I'm not 100% sure it will work for you but it should. Lastly this is still a work in progress. Thank you
My Car: 2015 Honda Civic Si
Materials:
Under the drive seat you will find 3 plugs. (Seat AirBag)(Seat Position Sensor)(Seat Belt Sensor)
![492088]( "492088")
Hopefully I will have pictures up for this soon.
Issues:
You will need a longer bolt for the rear seat hole where the harness bar and seat base goes. Will post a picture or specs once I find this.
I just recently swapped my driver side seat and wanted to give everyone some info/tips on this as I found it hard to find everything in one place. Below I will place all I have, i'm not perfect so please ask questions or post corrections. Please note that this is what worked for me I'm not 100% sure it will work for you but it should. Lastly this is still a work in progress. Thank you
My Car: 2015 Honda Civic Si
Materials:
- Seat: OMP (HA/741E/R TRS-E Racing Seat, Red
- Base: Planted Seat Bracket
- Base Hardware: Sparco (50001)
- Rails: Sparco Seat Rail
- Harness: Black Nylon SFI Seat Belt Combo, 3" Individual Shoulder Harness
- Harness Bar: Cipher Auto Harness Bar
- Air Bag: Bride Air Bag Seat Canceller
- Bolts, Nuts, Washers (For side harness)
Under the drive seat you will find 3 plugs. (Seat AirBag)(Seat Position Sensor)(Seat Belt Sensor)
- For the seat airbag I purchased an extra plug and wired the BRIDE Air Bag Seat Canceller - 2.0 OHMS to it.
![]()
- For the seat position sensor I removed the stock one from the seat. (You will have to raise the seat to the tallest position to do so (once you have the seat out) )
- For the seat belt sensor I purchased an extra seat belt with the sensor plug. But you can just remove the one from the stock seat.
Hopefully I will have pictures up for this soon.
Issues:
You will need a longer bolt for the rear seat hole where the harness bar and seat base goes. Will post a picture or specs once I find this.
