I know there are multiple threads on help and suggestions dealing with this topic, but this is by far the easiest way on the 2012 Honda Civic Si Coupe! I finally figured out the easiest way to run the power wire, remote wire and amp boost wire. It took me a few hours to do, but it was well worth it and it saved me lots of money, which is always good!
Listed below you will find step-by-step directions...
Listed below you will find step-by-step directions...
- Disconnect your negative battery terminal
- Look to the right side of your engine bay. You will see a black trim piece that runs along the right side. In the back of it you will find a rubber flap. You will be running your wire here and down along the fender to a plug below the hood latch.
-
- From the inside of your car, remove the plug behind the fusebox. It's below your hood latch wire. Run a 2+' piece of wire up through the hole and out to the engine bay at the rubber flap. Tape the wire and your power wire together. Pull the wire down through the hole. Drill a hole through the plug. Slide the plug onto the power wire, don't forget to do this before you run your wire back through your car.
-
- Look to Part 2 of this continued Post
